HVAC Site - Professional HVAC Contractors Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello everyone I'm currently a Junior Service Tech that's fairly new in the trade. I've been learning and picking up on everything I can. So if anyone has any advice or tips on servicing Furnaces and ACs contact me or reply here. I work in Northern Utah. 100% residential and my company works with Bryant, Day&Night, and Goodman.
My recent job was a Bryant short cycling but it wasn't giving an error code and the board was sending out the correct amount of volts to the entire system. I was a little stuck because it was my first time out by myself (it was the bosses house. They sent me out to see how much I learned) BUT I decide to replace the pressure switch and the flame sensor. It fired right up!

Sent from my Z981 using Tapatalk
 
1 - 4 of 4 Posts
Top