HVAC Site - Professional HVAC Contractors Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I would like to replace my 20 year old bryant thermostat with a wifi thermostat but I an not sure what else needs to be done to support the damper control. The thermostat is wired normally with the 4 wires and there is a temp sensor only for the second zone. The thermostat asks as master and I can set the temp for both zones from it. The control board is external to the furnace.

I believe the old thermostat model is a TSTATBBPRH01-B.

If there is any other information I need to provide then let me know.
Thanks
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top