HVAC Site - Professional HVAC Contractors Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter · #1 ·
I bought a browning laser aligner, it is very very easy to use and does a great job.
it was under $200.00
 

·
Tech./Sales Consultant
Joined
·
609 Posts
Remember when anything using a laser was thousands of dollars? This really is great technology in many areas of construction now.
 

·
Registered
Joined
·
149 Posts
I haven’t seen that unit yet. Do you have a link?

I looked into a laser shaft alignment kit a few years ago for pump motor shafts and couplings, but it was a couple of thousand dollars, so needless to say, I did not purchase it.
 

·
Registered
Joined
·
133 Posts
Discussion Starter · #4 ·
but ofcourse

http://www.easylaser.com/Belt%20Alignment.htm
i have the d90, but it was under 200 at ibt a belt place here in kc
trust me i also would not own it at 600


I haven’t seen that unit yet. Do you have a link?

I looked into a laser shaft alignment kit a few years ago for pump motor shafts and couplings, but it was a couple of thousand dollars, so needless to say, I did not purchase it.
 

·
Registered
Joined
·
149 Posts
but ofcourse

http://www.easylaser.com/Belt%20Alignment.htm
i have the d90, but it was under 200 at ibt a belt place here in kc
trust me i also would not own it at 600
Thanks for the info. You got some kind of super deal for sure… from $680.00 marked down to under $200.00!
I’ll have to keep my eyes open for a deal like that, but at full price it’s definitely just not in the cards right now.
 

·
Registered
Joined
·
250 Posts
Thanks for the info. You got some kind of super deal for sure… from $680.00 marked down to under $200.00!
I’ll have to keep my eyes open for a deal like that, but at full price it’s definitely just not in the cards right now.

Hell yeah that was one hell of a buy. Last time I looked there wasn't any good ones under $1500 out there.
 
1 - 6 of 6 Posts
Top