HVAC Site - Professional HVAC Contractors Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi there im dealing with a carrier package unit, i found a froze evap coil and of course a bad blower motor, so i replaced and noticed the pressures at 60 and 340 wow!! So i cleaned the coils and tryied again but it was the same and it was freezing up!
The i remove d the filter , clean the lines with high pressure and acid away and recharged it , but it got worst on the first start was 10- 150 psi, wow!!
Now i think is an obstruction in the capillaries but i want go make sure before doing a very expensive repair, any help? Please!!
 

·
Registered
Joined
·
2 Posts
Hello to everyone i have a question obout air cold chiller that i am manage. What is the most important. Part of the unit well be conduct for ppm

Sent from my C5502 using Tapatalk
 
1 - 4 of 4 Posts
Top