HVAC Site - Professional HVAC Contractors Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
What would the typical supply & install, cost/m2 for comparision be for the following methods of insulating ductwork?
- 25mm rigid mineral fibre slab
- duct wrap, flexiable blanket type

very approximate, struggling to find any data on this - thanks in advance.

(hope i posted in right place, apologies if not)
 

·
Registered
Joined
·
74 Posts
if your actual labor cost, including insurance and commissions, is $400 and your materials are $300, your total cost to do the job is $700. Mark that up so you get a net profit of 30 percent by dividing $700 by 0.70, and you get an increase of $300, for a total customer cost of $1,000. Set your overall markup percentage based on your break-even point to ensure that the job makes enough to pay your bills and, hopefully, makes a profit for the company.
 

·
Registered
Joined
·
21 Posts
if your actual labor cost, including insurance and commissions, is $400 and your materials are $300, your total cost to do the job is $700. Mark that up so you get a net profit of 30 percent by dividing $700 by 0.70, and you get an increase of $300, for a total customer cost of $1,000. Set your overall markup percentage based on your break-even point to ensure that the job makes enough to pay your bills and, hopefully, makes a profit for the company.
Thats good advice
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top