i would do a heat load calc to see what the house need vs what it has. 6 hr run time, damn. the units are design at 95 OAT as a standard.
Replies 24
what??!!
Replies 4
really??! why couldn't you?
Replies 9
side note* if you intend on running a business a clear line needs to be drawn between friends and customers. the difference may a liability you'd assume by allowing them to do y...
Replies 20
yeah, sound like it, only 30 days old is telling me the problem isnt the inducer, but the inducer may be a symptom of a problem. but goodman is goodman and i wouldnt doubt it ju...
Replies 8
why am i paying for the call, and what is the call for?
Replies 3
air scoop yes, if pump in return leg-point towards the boiler if in the supply leg-point away from boiler.
Replies 4
the txv should never be adjusted unless your looking to change you target superheat. check the subcooling to see if you condenser is putting out the right amount of liquid. also...
Replies 17
drippy water line at the connection. the remedy is to goo it up with some petroleum jelly.
Replies 8
if your trans is working fine between r and Y then it's not likely the transformer. if it was it would be doing that with r to g, r to y and r to w. it sound like there is a sho...
Replies 12
WTF? :blink:
Replies 20
what does that have to do with coil cleaning?:blink:
Replies 14
"Heating, Ventilation and Air Conditioning" by Cecil Johnson It's a residential and light commercial text and lab book. We use it here in the scholl I teach in. about $100
Replies 4
well....? what happened? how is it working now?
Replies 10
you'll be dead in a week, get you paperwork in order. i got dibs on your torch!
Replies 18
the superheat swing on the tev is based upon refrigerant pressure internal to the tev. You cannot expect the 410 to work with 22 tev's. those valves must be replaced immediately...
Replies 7
awesome, now that the evap have the right amount of refrig. it can pull more latent heat out and bring the temp. lower. next step is to see if it has a leak somewhere.
Replies 10
the sight glass needs to be filled with liquid, if not you are not delivering the full volume of liquid refrigerant the TEV needs then the evap cant do it's job. check the TEV's...
Replies 10
leave the TXV alone!! the superheat adjustment is not meant for that. if you super heat is too high then its an indication that the evap is starved. try installing a sight glass...
Replies 10
why are you adjusting the TXV?
Replies 10
